ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER
ISONIC EXPERT CORNER

ISONIC EXPERT CORNER CU

Lieferzeit: 3 - 4 Wochen
Preis auf Anfrage
Lieferzeit: 3 - 4 Wochen

Inspection of Corner, Nozzle, L-Shape welds - planar cross section of the base surface

Anfrage Informationen |   EU-Mehrwertsteuervorschriften | Lieferung

ISONIC EXPERT CORNER software application was created for the inspection of Corner, Nozzle, L-Shape welds, and the like, and the like with use of wedged linear array probes situated on the flange or web surface

ISONIC EXPERT CORNER CU software application was created for the inspection of Corner, Nozzle, L-Shape welds, and the like with use of wedged linear array probes situated on the curved flangesurface

Both software options are available for the ISONIC 3510ISONIC 2010, and ISONIC 2009 UPA Scope instruments and featured with:

  • Built-In Weld Geometry Editor and Ray Tracer - Scanning Pattern (Scan Plan) Design
  • Intuitive Image Guided PA Pulser Receiver with Beam Forming View
  • Automatic Curvature Correction for the wedges with contoured contact face (FILLET CU)
  • True-To-Geometry Weld Overlay Volume Corrected Imaging - Cross Sectional and Top (C-Scan)- / Side- / End- View and 3D through Sector-Scan Cross Sectional Coverage and line scanning along the fusion line either encoded or time based
  • DAC / TCG Data / Image Normalization
  • Independent on TCG Angle Gain Compensation / Gain Per Focal Law Correction
  • Automatic Coupling Monitor
  • 100% Raw Data Capturing
  • Automatic Defects Alarming Upon C-Scan Acquisition Completed
  • Automatic Creation of Editable Defects List
  • Comprehensive Postrpocessing Toolkit Including:
    • Recovery and Evaluation of the Captured A-Scans from the Recorded Cross Sectional Views (Sector Scan) and C-Scans
    • Recovery of the Cross Sectional Views from the Recorded C-Scans
    • Converting Recorded C-Scans or their Segments into 3D Images
    • Off-Line Gain Manipulation
    • Off-Line DAC Normalization of the Recorded Images / DAC Evaluation
    • Numerous Filtering / Reject Options ( by Geometry / Position / By Amplitude db-toDAC / etc ) and Regeneration of the Corresponding of Editable Defects List and Storing it into a Separate FIle
    • Defects Sizing
    • Automatic creating of inspection reports - hard copy / PDF File
0 Artikel

NEWSLETTER ABONNIEREN

Produkt zur Wunschliste hinzugefügt