ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING
ISONIC EXPERT A-RING

ISONIC EXPERT A-RING

Lieferzeit: 3 - 4 Wochen
Preis auf Anfrage
Lieferzeit: 3 - 4 Wochen

Detection, imaging, and evaluation of the pitting corrosion damages in the fillet weld area up to 100 mm (4 inch) inside the above ground storage tanks

Anfrage Informationen |   EU-Mehrwertsteuervorschriften | Lieferung

ISONIC EXPERT A-RING software application was created for the detection, imaging, and evaluation of the pitting corrosion damages in the fillet weld area up to 100 mm (4 inch) inside the above ground storage tanks with use of the PA probe situated on the external lip. The in-service inspection does not require the emptying of the tanks and may be performed at any moment

This software option is available for the ISONIC 3510ISONIC 2010, and ISONIC 2009 UPA Scope instruments and featured with:

  • Built-In Annular RIng Fillet Weld Area Geometry Editor and Ray Tracer - Scanning Pattern (Scan Plan) Design
  • Intuitive Image Guided PA Pulser Receiver with Beam Forming View
  • True-To-Geometry Annular RIng Fillet Weld Area Overlay Volume Corrected Imaging - Cross Sectional and Top (C-Scan)- / Side- / End- View and 3D through Sector-Scan Cross Sectional Coverage and line scanning along the tank shell either encoded or time based
  • DAC / TCG Data / Image Normalization
  • Independent on TCG Angle Gain Compensation / Gain Per Focal Law Correction
  • Automatic Coupling Monitor
  • 100% Raw Data Capturing
  • Automatic Defects Alarming Upon C-Scan Acquisition Completed
  • Automatic Creation of Editable Defects List
  • Comprehensive Postrpocessing Toolkit Including:
    • Recovery and Evaluation of the Captured A-Scans from the Recorded Cross Sectional Views (Sector Scan) and C-Scans
    • Recovery of the Cross Sectional Views from the Recorded C-Scans
    • Converting Recorded C-Scans or their Segments into 3D Images
    • Off-Line Gain Manipulation
    • Off-Line DAC Normalization of the Recorded Images / DAC Evaluation
    • Numerous Filtering / Reject Options ( by Geometry / Position / By Amplitude db-toDAC / etc ) and Regeneration of the Corresponding of Editable Defects List and Storing it into a Separate FIle
    • Defects Sizing
    • Automatic creating of inspection reports - hard copy / PDF File
0 Artikel

NEWSLETTER ABONNIEREN

Produkt zur Wunschliste hinzugefügt